Wireless

We are running 4.2.112 code on the 2 controllers on our WiSM blade. While making multiple ldap/local EAP changes on one of the controllers via http, that particular controller becomes inaccessible via http/ssh but it still processes traffic and it ca...

This might be more of a question for Cisco but in WCS you can configure an AP to use up to 3 controllers. That is great but what if you are running dual WiSM modules, then you would have 4 controllers but you can't configure the AP's to use the fourt...

While in the "Synchronize WCS and Location Servers" section of Wcs I am unable to assign a location server to a created network design. I keep getting a red asterick or bang. Any thoughts?Thanx Chris

I have attached a screenshot.I am running this unit using a power injector. I have no power issues, and the 2.4GHz antenna is up and running fine.I have the 3 antennas installed on the 5GHz transceiver, and don't see any other problems in the setup....

Hi,I got a Wireless Controlleer with a few APs. Now testing EAP auth. Clients fails to authenticate on the network using EAP-TLS. Client status shows as Associated but Auth as No. Ive attached the client debug. It got stuck on "Unable to transmit key...

The 1300 with connectors for external antennas, have it integrate antenna?

Hello friends, I have a problem with a couple of AP 1400 and 1300, which perform point-to-point links between two remote locations. The person who administers these devices is no longer. At the time of accessing the computer does not know the passwor...

Hello,Does anyone know how long the data collection process takes during the calibration process for lbs? I have read in the design guide (4.1) that it can take up to "a few minutes". Is this per data collection point? If so, how far apart are these ...

I fell in the problem described in http://www.cisco.com/en/US/partner/tech/tk827/tk369/technologies_tech_note09186a0080093f1f.shtmlA server sent a MTU greater than 1500 and the frame wasn't able to pass thru a GRE tunnel.I am asking if the same probl...

I tried to use the GUI to upgrade my 1120 and mucked it up. The upgrade wiped out the flash but failed to upload the new .tar file. Now my AP is running (i haven't rebooted it) but I have no GUI. So, I have access to the CLI, I have a tftp server...

Hello,The volume of wifi users within my organisation is set to increase by approximately 50% in the coming months. We are currently using Cisco Aironet 1200s which are providing a strong /good quality signal for all users. I need to know what is b...

Hello there,I have following situation.network---wlan controller4402----FW1---MPLS---FW2---Access points----networksI can see very big amount of fragmented packets coming to FW2 and getting dropped in one moment. After those packets get dropped, acce...

HiI have a WLC4404 with the last release, 5.0.148.0, and it suddenly rebootsAnyone has the same situation?Thanks

I've been reading over the "Cisco Wireless LAN Controller Configuration Guide, Release 4.0".So it looks like once you have the HTTPS enabled and the management IP set, the majority of the configuration is through the GUI - clicking your way through a...