Adaptive policy

[Ambuj M]

I am seeing multiple issues with assigning SGTs, I have relevant HW ad Licenses.

when I assign SGT at SSID level the SGT disappears as soon as I save it

after saving

I though it may be cosmetic, the capture on wired interface do not show any CMD header.

then I thought let do it through group policy but same issue as soon as I save SGT in group policy it disappears.

has anyone seen this work ?

when I assign SGT from ISE for other SSIDs I can see the SGT tag, not nothing seems to work natively from Meraki.

[Philip D'Ath]

Are you running 27.x firmware or better?

Does the network only contain Wifi5 wave 2, Wifi6, and Wifi6E MR or CW access points?

[Ambuj M]

Yes

[Ambuj M]

So upgrading from 29.x to 30.x resolved this issue, I can assign SGT on ssid and it stays there, I can see the CMD header in capture now.

I also notice peer sgt was not enabled on some of switch port connected to AP, but the one was I capturing had it enabled.

not able to save sgt in group policy is expected behavior, feature supported in 31.x (in beta) not 30.x that I am running.