Add controller in Cisco Prime

[pedromenezes]

Hello guys

When I add a controller in Cisco Prime all the access points that the controller manages are added automatically? Or I have to manually add one by one?

My problem is that when I try to add an access point with the snmp community that I configured in the controller the following error appears: "Verification of one or more of the following fields failed: SNMP read community, SNMP write community.

[Sandeep Choudhary]

once you will add a controller in prime, all APs assosciated to that WLC will be in prime as well.

Regards

Dont forget to rate helpful posts