Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Dears, i want to recover the password for Mobility Express WLC which has registered 7 no's of AP's thanks
Dears. I have 15 APs (2800 & 2700) installed, discovered by the controller and in REG operational status. After i tried to move them to a certain group (WLAN Group) they got disconnected and i am unable to reach them to collect logs as they are insta...
Hi All, I have couple of questions on the Cisco prime tokens Is the grandfathered token only available for Assurance License My customer had procured some lifycycle license for NCS which I directly used in Prime 3.1( customer was not using it for 3 ...
There´s an Issue trying to make Phone calls from different cellphone type (Iphone, Huawey, Samsung) each phones has te capability to make calls at a domestic wireless LAN with out problems. At the company we have AIR-CAP2602I-A-K9 antenas attach...
HI , anybody know about RFID system from Cisco and what components needed ?
Hi Guys, Trying to get my head around with the concept of MU-MIMO introduced in 802.11ac. Based on Cisco, AP can send multiple data frames to multiple users at the same time, I am just wondering how it is possible with CSMA/CA. My understanding is if...
Hi, We need to configure cisco AIR-SAP2602I-E-K9 for 2 SSIDs. One Domain Users and another for Guests. Vlans are configured in cisco switch. Vlan1 is for Domain Users and Vlan 23 is for Guests. Can we have a simple configuration example? Thanks.
Hi All,I have a customer who have Cisco Prime 3.0 with 1025 lifecycle licenses. There are used 990/1025, primarly for accesspints. Now they would like to add additional devices.- Over 100 pieces of Cisco Routers 4451 - More then 1000 of switches 3500...
I have Cisco 1142 configured in autonomous mode and connected to RVS4000 router. I want to create two SSIDs i.e. one private and other guest. The idea is that users connected to either of the SSIDs should not interact with each other i.e. able to pin...
I can't seem to find an evaluation of the virtual appliance for Cisco Prime Infrastructure version 3. I'm only finding version 2.2.Could someone point me in the right direction?Thanks!
We have two 5508 controllers. One is set up to be Primary (Master Controller) and the other Backup. We have several campuses connected via fiber to 3850 switches. Have an issue at one campus after they lose connectivity to Primary. The APs move ...
Dear All, I am facing a strange issue while configuring Cisco WLC 5520 and Cisco 3850 switch. I have assign IP address 192.168.66.1/24 to WLC Management and untagged it. Created vlan 66, create SVI assigned IP 192.168.66.254/24. WLC is connected on T...
Hi all, is there anyway of removing ports from LAG, we are getting multiple Prime 3 alerts because ports are down on the WLC, I need to admin shut them to stop Prime reporting Blocked: Lag is enabled. Disabling the lag port is blocked when system is ...
Hello, I have a system of 5 APs 1831c. Actual mobility express controller release is 8.2.141.0 and I want to upgrade it to the new 8-2-151-0. I donwloaded the firmware AIR-AP1830-K9-ME-8-2-151-0.zip but I don't know how to upgrade it. If I try to up...
what are the pros and cons of very small AP Groups? I am talking about AP group with 1-3 APs in them, is there a best practice on a minimum number of APs in an AP Group. how would we approach RF Profile and RRM in such type of AP Group.
