Add Radius server now CLI wants authentication

[GreenWifi]

I have a new C9800-CL and I've added a Radius server for 802.1x authentication.  I wanted to check some settings in the CLI and now I'm not able to get to the enabled prompt.  It prompts for login but when I do login I get "% Error in authentication."

I can run commands from the Command line GUI portion and it does work.

I believe it has to do with the Radius server as I have another C9800-CL and have not added the Raduis server and I have no problem with the CLI or running commands.  

What do I need to do so I can get CLI access?

[Rasika Nayanajith · Accepted solution]

Did you follow this document when configuring ? If not have a look, it may help

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/214490-configure-radius-and-tacacs-for-gui-and.html 

HTH

Rasika

*** Pls rate all useful responses ***

[GreenWifi]

Once I added the login group to Authentication and exec group to Authorization I was able to use the CLI in enable mode.  

[JPavonM]

If you cannot change configuration from GUI you must follow the password recovery procedure in the next document.

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/214012-recovering-a-catalyst-9800-controller-fr.html

HTH

Jesus

*** Rate All Helpful Responses ***