Hello everyone,
I have a question about creating a WLAN for a remote location on a 5508 WLC that's housed at our main office. Attached is a diagram of the connection between the two locations. My question is, how do I set this up? Our WLC is at our main office (10.1.x.x) and I was able to get a lightweight AP to join the controller using an IP address from the local subnet of the remote location (10.20.x.x). However, I want to create a new subnet that will be broadcast at the remote location only and clients will use the local DHCP/DNS server there. Usually, I create a new interface when I set up a new network but I have to specify a VLAN ID. Since the VLAN at the remote location is also VLAN 1, how do I go about doing this? Do I create an untagged interface? Please help!
Regards,
Terence
