Having issues adding three additional AP to the 1852i Controller. I have the primary controller setup on 1 of the AP, but when I connect any of the other 3 1852i APs, the controller is not able to detect it. Following the instructions, it says I could just connect the other APs and ensure it is on the same subnet, and they are.
I am able to access the management page of the controller through a web browser.
All the APs are connected to Catalyst 3560-CX - 12 Port.
My Cisco 7925G phone is connected to the wireless from the controller AP and it is making calls.
Not sure if I missed a step in the setup process to ensure any additional APs I connected to this same subnet will be recognized by the controller.
Any ideas on what I could do to get the other APs to be recognized by the controller?
SierraVista-3560CX_2#show arp
Protocol Address Age (min) Hardware Addr Type Interface
Internet 192.168.0.245 - 005f.8696.fac1 ARPA Vlan10
Internet 192.168.20.1 5 64f6.9d27.8900 ARPA Vlan20
Internet 192.168.20.6 - 005f.8696.fac2 ARPA Vlan20
Internet 192.168.20.181 179 0038.df3a.39f0 ARPA Vlan20 'This is the controller'
Internet 192.168.20.188 29 0038.df3a.4958 ARPA Vlan20
Internet 192.168.20.218 3 0038.df3a.3bf0 ARPA Vlan20