Per Cisco Documentation :
The APs that support this migration are:
· All 1121 access points
· All 1130AG access points
· All 1240AG access points
· All 1250 series access points
For all IOS-based 1200 series modular access point (1200/1220 Cisco IOS Software Upgrade, 1210
and 1230 AP) platforms, it depends on the radio:
¨ if 802.11G, MP21G and MP31G are supported
if 802.11A, RM21A and RM22A are supported
The 1200 series access points can be upgraded with any combination of supported radios: G
only, A only, or both G and A. For an access point that contains dual radios, if one of the two
radios is an LWAPP-supported radio, the upgrade tool still performs the upgrade. The tool
adds a warning message to the detailed log that indicates which radio is unsupported.
¨
·
· All 1310 AG access points
Cisco C3201 Wireless Mobile Interface Card (WMIC)
Note: The second-generation 802.11a radios contain two part numbers.
·
Access points must run Cisco IOS Release 12.3(7)JA or later before you can perform the upgrade.
So I am thinking your answer is yes it can be done.
You must use the Cisco Upgrade tool and current IOS must be at 12.3(7)JA or better.
I know the 1230AG can be done as I have done several.
I know the 1200AG cannot be done as I have tried several.
Not sure on the mesh issue - Anyone else know the answer to that.
Hope this helps.....
