Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
i have successfully been able to configure my 891w router with a wireless network, but even when i allow the SSID to broadcast (Using the GUI option Enable Broadcast), as soon as i save the settings with the SSID broadcast enabled. it goes back to SS...
Hi FolksHow re-authenticate a WiFi User and prompt him again to enter onother username and Password ,we are using single signomusualy what i been doing is to delete the wireless Profile and add it again in order to put another username and password t...
hi there,how a port in a switch is blocked to avoid network loop? i too wanna know how a root port is chosen ...?? thank u
I have installed the tool on an XP laptop.If I configure the tool to use an external tftp server then I get upgrade failed."Unable to Load the LWAPP Recovery Image on to the AP"If I use the built in tftp server I get a msgbox with "C:\Program Files\...
We're doing an experiment with using Radius to logg users in. It seems to be working fine except for one thing: I can't find how to set defaults for the various settings for the users. E.g. profile name, how long the account should last etc. The loca...
Location services are listed under MESH network unsupported features. There is a short notice only in Release Notes. I can't find any other more technical info about that. Did anybody make some tests? What does the unsupported mean? Is it absolutely ...
My WLSE 1030 hard drive failed and I have replaced it with a new drive but when I boot from the 2.15 recovery CD the disc boots and runs, within the console connection I get the error "ERROR: version information not found in flash" the disc is the ej...
ap is AIR-AP1142N.SSID & RADIO 1 configuration is that....enable ssid on the radio 0 -> i see the ssid (but 72mbps..)but, shut radio 0 after enable the radio 1 -> i don't see the ssid 802.11n configuration is authentication open or wpa2 and aes encry...
Hi,I have configured an antenna AIR-ANT2430V-R 2.4 gHZ for LAP 1262N-A-k9 using WLC-2106.The devices that are going to associate are hand helds that just support standard b,g; so I would liketo know if It would have any advantage if I enable all the ...
Hi,Quick question. WCS is currently auditing three WLCs (4400). We are trying to add a new WLC (same model and version) to the WCSand its reachable (but gives the error audit status not available).SNMP is configured correctly on both sides, there's I...
I'm going to install a Cisco Aironet 1310 with AIR-ANT2506 external antennas, someone will have the best practices for the installation of these antennas, considering that they will be installed on metal beams. Do I Need to install two antennas or ju...
hi,which is the ios image for LWAPP 1242ag series?
HiWe have a WLC4402management interface IP is192.168.0.10 on the192.168.0.0/24 network. VLAN 105Dynamic interface 10.31.0.4 on the 10.31.0.0/24 network for wired en wifi users VLAN 101 SSIDV101another vlan (106) where RADIUS and other server are.(not...
hi,how can i load new ios image to cisco 1242ag series ap which is lwapp.i want to load the same ios image as before.
I have a WAP4410N access Point, firmware 2.0.1.0. I have configured a Kiwi syslog server to get the log from the WAP4410N, but the log information obtained is just the "standard event log" and not the detailed log (every connection source and destina...
