Hello,
I was in the process of upgrading the Firmware, and converting it to ME.
Now the AP is stuck in a boot loop. I press the MODE button, and apply power to the AP, and rather than go to UBoot, it goes directly to the board selection screen.
Please choose one of the following boards:
1. 3K
2. 2K (new)
3. 2K (proto)
4. Milos
5. 2KH
6. 3KVE (v-sku)
7. 3KH/3KA/4K
init>> High speed PHY - Version: 2.0
BoardId = 0x21board SerDes lanes topology details:
| Lane # | Speed| Type |
------------------------------|
| 1 | 0 | SGMII1 |
| 2 | 5 | PCIe1 |
| 4 | 5 | PCIe2 |
| 5 | 0 | SGMII2 |
-------------------------------
:** Link is Gen1, check the EP capability
PCIe, Idx 1: Link upgraded to Gen2 based on client cpabilities
:** Link is Gen1, check the EP capability
PCIe, Idx 2: Link upgraded to Gen2 based on client cpabilities
High speed PHY - Ended Successfully
DDR4 Training Sequence - Ver TIP-0.23.(Sublib 0.8)0
DDR4 Training Sequence - Switching XBAR Window to FastPath Window
DDR4 Training Sequence - Ended Successfully
BootROM: Image checksum verification FAILED
BootROM: Bad header at offset D4200000
And as you can see, it looks like my image file maybe corrupted.
how do I get back to a UBoot screen so that I an TFTP a new image, or Firmware file to the AP?
Kind regards,
John
