12-07-2001 08:58 AM - edited 07-04-2021 10:54 PM
We have buyed 2 wireless bridge AIR-BR350-E-K9 but in configuration is impossible to set this 2 units as bridge, there are only 3 field: As AP, as repeater and the last as client.
Someone have had this kind of problem?
12-14-2001 04:28 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
12-19-2001 04:54 AM
I received a field notice that said "For a specific number of kits, access points labeled as bridges were shipped. These bridges did not contain all of the necessary options in the web browser configuration pages."
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide