AIR-CAP3602I-N-K9 factory reset fail

[jacob.mmchan]

Dear Wireless Experts,

I had tried to make the factory reset a AP (AIR-CAP3602I-N-K9) and I pressed over the time on MODE button.

Now, I boot the AP every time and the console is only showed as Ranma. Any idea to reset it back to normally?

[Scott Fella]

If you mean ROMMON, then there are a lot of information online.  Here are a few you can reference.

Access Point ROMMON Recovery AP: prompt Recovery Example - Cisco Community

Configure Cisco AP in ROMMON mode (Recover from Corrupted Image) - IP Mechanic