cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
888
Views
0
Helpful
2
Replies
animedreamer
Beginner

Aironet 1142N

Does anyone have a simple configuration for the Aironet 1142N?  Optimally, I would like to place 802.11b/g traffic on the 2.4 GHz band and 802.11n traffic on the 5 GHz band.  Any assistance with this is most appreciated.

Thank you,

Vincent                 

2 REPLIES 2

Hi Vincent,

Welcome to CSC.

Below is a link for a basic autonmous config.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008055c39a.shtml

When you configure 802.11n you need to insure you are using WPA2/AES and WMM enable.

__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Thanks, but do you have an example that shows the raw IOS output?  I have to configure several of these and rather not have to do it via the GUI.

      

Also, is there any more current documentation?  The example indicated walks one through setting up WEP encryption, an obviously insecure and defunct protocol.

Lastly, I don't see how that example addresses the issue of segregating the 802.11b/g traffic on the 2.4 GHz band and the 802.11n traffic on the 5 GHz band.

Thanks,

Vincent

Create
Recognize Your Peers
Content for Community-Ad