05-08-2012 12:58 PM - edited 07-03-2021 10:08 PM
I need to upgrade a 1230 to the new Aironet 1250 at a location. I have only 2 external antennas at that location.
I understand that you still can run 802.11n with 2 antennas.
But I can not find anywhere in WLC 5508 v7.2 that I can disable the middle nut (C)
Please advise.
Solved! Go to Solution.
05-08-2012 01:00 PM
the middle nut is a Rx only, so you wouldn't need to disable it really.
But if you go to Wireless > 802.11a (on the left) > then pick the AP you want to configure, you can uncheck that box. This is a per AP config, so could take you a while.
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
05-08-2012 01:00 PM
the middle nut is a Rx only, so you wouldn't need to disable it really.
But if you go to Wireless > 802.11a (on the left) > then pick the AP you want to configure, you can uncheck that box. This is a per AP config, so could take you a while.
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
05-08-2012 01:07 PM
It works, thank you
05-08-2012 01:05 PM
When the ap is joined to the wlc, you can click on the blue arrow on the right side of the ap listing that says configure. IIRC, it there where you can set what ports you will use.
Thanks,
Scott Fella
Sent from my iPhone
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide