Alarm/Alert Threshold Configuration

[zdesignstudio]

Is there currently a way to modify alarms related to interferences on a per interference level? I have looked all over and I can only find enabling or disabling them but not adjust them as granular as we would like. We have APs located all over the country in locations that house a good amount of Guest traffic and BYOD. We get slammed with DECT Like phone, WiFi Invalid Channels, Inverted Channels all the time. We don't want to just stop alarming or alerting on them, but rather adjust the sensitivity to account for this specific environment.

Cisco 8510 Controller w/ 7.6.120.12 software

Cisco 5508 Controller w/ 7.6.120.0 software

MSE w/ 7.6.120.0 software

Prime Infrastructure 2.1

[zdesignstudio]

Anyone?

[rsaeks]

There are some settings you can change on the WLC relating to alert / alarm levels in areas like client density, interference, etc.

You can find those under Wireless > 802.11a/n/ac or 802.11b/g/n > RRM > Coverage or General depending on the setting.

Randy