AP 1240 to non Cisco

[richmorrow624]

We have some non Cisco AP's that I am trying to configure a Cisco AP 1240 to associate with.

The radio will not come out of "disabled"

Antenna is connected and I have done the basic config, there is no security set up at all on the existing untit.

What are the basic setup parameters for the raido to assiciate with the other side?

are there any debugs I could look at?

[alinn]

Hello Rich,

AP 1240s will not link up with any 3rd party devices.

To make a bridge link with the 1240 another Cisco make AP would be needed.

Regards,

Aaron