AP 2802i constant reboot with error: Hardware is NOT Cisco

[NicoMat]

Hello,

I have an AP 2802i that worked perfectly until was rebooted and now is not booting.

I did found the bug "CSCuy03596" , but no solution for.

I cannot request replacement because of missing contract support for APs.

Do you have a solution for updating the firmware from u-boot?

Message is:

[*07/19/1986 05:02:02.1300] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)

[*07/19/1986 05:02:02.1300]

[*07/19/1986 05:02:02.1300] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)

[*07/19/1986 05:02:02.1300]

[*07/19/1986 05:02:02.1300] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)

[*07/19/1986 05:02:02.1300]

[*07/19/1986 05:02:02.1300] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)

[*07/19/1986 05:02:02.1301]

[*07/19/1986 05:02:02.1301] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)

[*07/19/1986 05:02:02.1301]

[*07/19/1986 05:02:02.1301] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)

[*07/19/1986 05:02:02.1305]

[*07/19/1986 05:02:02.1305] (ACT2Boot) Hardware is NOT Cisco (c) authentic

[*07/19/1986 05:02:02.1306] System will reboot in 10 seconds ...

[*07/19/1986 05:02:12.1319] ... rebooting now!

[balaji.bandi]

if you get chance upgrade the version suggested in the bug to fix.

[NicoMat]

The AP had the 8.5.131 version, when crushed. But still, I cannot do it over u-boot. Seems the option is not here.

So, no chance for fix it?

[Leo Laohoo · Accepted solution]

RMA the AP. 

The AP is covered under Limited Lifetime Hardware Warranty.