AP 521 after conversion from autonomous doesn't work

[eidoslanesi]

I have buyed a WLC-526 and three AP521 AP. On the first AP521 I used the "Convert to LWAPP" tab in the configuration drawer, according Cisco procedure and after that I downloaded the c520-rcvk9w8-tar.124-10b.JX.tar image. After the procedure running, the AP521 goes in continous loop reload.

What's wrong? How can I recovery the initial image.

thanks an advance

martog

[dancampb]

Depends on how far the bootup is going. After the AP is converted to LWAPP it will keep rebooting if it can't find a controller to join.

[eidoslanesi]

The WLC 526 is on the same subnet as APs.

martog Thanks