Wireless

i'd like to know on how many number of users can a 1130 AP support (i know by default the threshold is set to 12) if i have 24 users connected connected to 1 AP, will the users experience poor signal and experience connectivity issues? what is the be...

I have a guest wireless wlan setup. When guest users attach to our guest wireless they are prompted by the built in web security on the WLC's. Cisco talks about how to setup the WLC to route web authentication to an external web server, but they don'...

Hi all - setting up NAC guest Server.I want to pull the sponsor users in from active directory group. I have set up to connect to a domain controller with success (test successful) and then added the domain controller but when clicking on the active ...

I need to set up MAC authentication for a bunch of systems. I'd like to import the data from a file as there are quite a few of them, but I can't seem to get the format correct for the import file.Is this documented somewhere? Or does anyone know wha...

I am trying to set up a bridge network that does not have direct line of site. I just want to verify that the configuration is nothing special. There is a building blocking a direct P2P connection so I need to add a bridge in the middle acting as wha...

I need to grab the CPU and memory utilization statistics for a Wireless LAN controller but it doesn't look like they exist in the typical location for a Cisco device.

Hi, I have 20 1522AG's in lightweight mode running on a 4400 controller. Firmware is all 6.0.My issue is that the wireless interfaces on these access points are frequently going down and then immediately back up. This happens on each access point mul...

our users are using some 3rd party radius server for MAC address auth. I found there is a setting called Radius compatibility mode in the WLC configuration. But there is no document talking about what this setting does for. So should I set it to use ...

Hi, I have a 1801 ADSL router. I have a Bridge group 2 configure with a BVI interface, this is also bridge onto VLAN 2 so I have a server on VLAN 2 which acts as a media server.when I connect to the WLAN I can get to the internet. But cannot connect ...

I have a 4404 controller that I want TTLS to work with so I can encrypte surfing of the wireless network.I installed FreeRadius 2.0 and looked in the eap.conf file. Under the TTLS section I did this:ttls { default_eap_type = md5 copy_request_to_tunne...

I have a customer that would like to mount the 1522's on top of Buildings. They already ordered the Pole Mounting kits - which include a bracket that would allow them to flush mount to the walls. The customer is looking for something like the 1310 mo...

Hi,I have an environment with WISM release 6.0 and 7921 with firmware 1.3.2. This is the issue that I have, when the signal from the AP on the phone display is around 2 step ( 5 step is full signal) the call remains active but the conversation become...