AP, console connection issue

[Asfandyar70754]

Hello everyone

I reset one of my Access point(Aironet 1600), and now I have not been able to connect it using console.

First I thought there might be some problem with my console cable, but I tried it on switches and it worked alright.

What could be the issue.

Any help is appreciated

Thank you

[Sandeep Choudhary]

Hi,

Use the following settings for the terminal emulator connection:

9600 baud
8 data bits
None parity
1 stop bit
Xon/Xoff Flow control .If xon/xoff flow control does not work, use no flow control.

Regards

Dont forget to rate helpful posts

[Asfandyar70754]

Hi Sandeep

Before doing reset, I used the same console cable to access my AP. 

But I still will try different console cable, to see if it works.

[Scott Fella]

What was your terminal set to? Was it the same as what was sated int eh post above? Keep in mind that there have been a lot of people here saying that their console cable works on a switch and doesn't work on the ap. I have also seen this and that is why I have specific rj45 to usb FTDI (https://www.amazon.in/CABLESETC-Console-Adapter-Converter-Windows/dp/B07MM5C11H/ref=sr_1_2?dchild=1&keywords=usb+to+rj45+console+ftdi&qid=1593446050&s=electronics&sr=1-2) This is what I have been using for many devices: https://www.amazon.in/Asunflower%C3%82%C2%AE-Cisco-Console-Cable-Windows/dp/B00RHDXDWA/ref=sr_1_7?dchild=1&keywords=usb+to+rj45+console+ftdi&qid=1593446050&s=electronics&sr=1-7