AP Controller IP DHCP Problem

[Sebastian Helmer]

Dear all,

its not my first config or location but with the 2600 I have now a problem.

Any ideas?

*Mar  1 00:17:04.255: %CAPWAP-3-DHCP_RENEW: Could not discover WLC using DHCP IP. Renewing DHCP IP.
*Mar  1 00:17:07.327: %DHCP-6-ADDRESS_ASSIGN: Interface BVI1 assigned DHCP address 10.X.Y.101, mask 255.255.255.0, hostname APc08c.6024.cfc8

Translating "CISCO-CAPWAP-CONTROLLER"...domain server (255.255.255.255)
*Mar  1 00:17:14.255: %CAPWAP-5-DHCP_OPTION_43: Controller address 10.A.B.30 obtained through DHCP

The AP will use the 10.A.B.30 as Controller...when I enter the Controller IP manually it works..

best regards,

Sebastian

[Rasika Nayanajith]

Error msg you saw when booting AP is not normal. Try delete NVRAM config of your AP & see.

AP#debug capwap console cli

AP#erase /all nvram:

If  none of these work, I would format flash & bring it back. Steps listed in below post

https://supportforums.cisco.com/thread/2045805

HTH

Rasika

**** Pls rate all useful responses ****

[Sebastian Helmer]

In my office it works fine, attach to network, wait a few minuntes and BAM it is on my WLC just via DHCP option.., so there is something with the DHCP setting on that site I guess...I will find it out and check it once again ;)...

thanks to all..