07-17-2007 06:35 AM - edited 07-03-2021 02:21 PM
Two WLC4402 (Version 18.104.22.168)with AP1010's.
AP Fallback Enabled.
RF Group and Mobility group set
Sysname used to define Primary and Secondary.
Everything works except 'falling' back to the primary when it comes back online.
Does anyone have this working ?
Same problem on 4.0.217
The only bug I can find says 'fixed' but does not give a version only first detected in 4.1.169.
Any help gratefully received
07-18-2007 07:17 AM
I have this working in my lab. If your mobility groups are configured correctly, the AP should move when it's configured primary comes back on line, FYI the sysname applied to the controller for primary/secondary/tertiary, are case sensitive.
Run debug mac addre < AP mac address>
debug lwapp events enable
debug pm pki enable
These will let you see if the AP is sending the primary discovery request, and what response it is seeing.
07-20-2007 06:10 AM
07-20-2007 06:49 AM
If I understand correctly, it is only happening to one of the APs?
If so, have you tried resetting the AP back to factory defaults?
07-20-2007 08:17 AM
There only two AP's currently as they are in lab environment.
One has WLC-A (primary),WLC-B (Secondary) and the other is reversed.
07-20-2007 08:29 AM
Hmmm.... You are not running WLB-B as a master are you?
07-20-2007 08:40 AM
No, and I have done factory resets on them because I had seperate problem with AP groups which was fixed by the reset.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: