Wireless

Can anyone remeber what the command is to make the LED flash on the 1130AG Access Point?

How can I discover lightweight 1131AG Access Point using 2106 WLAN Controller.

somebody knows how to use(configure) the network routes in the wlc 4402?

hi all,when i config WCL 4402 like:IP on Management Interface: 172.16.1.1 255.255.255.192dhcp: 172.16.1.1IP on AP-Management interface: 172.16.1.2 255.255.255.192dhcp: 172.16.1.1i make scope on WCL: 172.16.1.20 - 172.16.1.40i connected WCL4402 and AP...

i wanto upgrade 1131ap to lightweight ap throuth WAN,can use the upgrade tools2.05 do it.thanks.

I have a question concerning the operation of the wireless network and the WiSM in a 6500 that we have put in place. My customer has the following setup: On thier mainsite, they have a core 6500 with a WiSM module in place. They have 4 remote sites, ...

dear i wanna to configer internal dhcp in WISMhow can ii need the pool start from 10.30.101.50 t0 200 /24 (255.255.255.0)the network 10.30.101.0netmask 255.255.255.0the defoult router must be the WISM-A ip address10.30.101.2also i configured the DNSa...

I want to add an access list to permit only http traffic on my dynamic interface (wlc 4402), vlan12. I haven't found any examples of ACL configuration on a 4402. So far I have tried the following permit statements, with no success. permit tcp http an...

We have some 1130's running multiple vlans. However, we are not seeing DHCP info get past the AP's. The AP's are not using LWAPP but IOS and are being trunked backed to a 6509 CATOS. Any ideas?

Hello,i try to connect a Notebook with an integrated Intel PRO/Wireless NIC to an AP1240. Both are comletely blind to each other. The NIC can see another AP (FritzBOX WLAN) without problems. When inserting a CISCO PCM352 NIC its all ok, too. But its ...

I have a situation where I have three WiSM's or 6 controllers. The last WiSM we installed I have configured with a different mobility group due to the rev. of code that is on the new one. The new one is at 4.0.217.0 and the old ones are at 3.2.171.6....

I am running a WLC 4402 and have WPA/TKIP configured on my one SSID. After a while it stops processing client requests that are coming in using PEAP. It works for a couple of days using PEAP and then starts rejecting it. I can use LEAP at all times w...

I am having trouble joining my wireless laptops to my Windows domain. The wireless devices are connecting through a 1242 AP. If I take the same laptops and hardwire them they join without issue.Any ideas what could cause this issue?Thanks in advance!

How the autonomous access points are registered using WLSM? And how are configured the port than connect the Access Points, they are configured than Access or Trunk ?