AP issue

mzedanmzedan · ‎09-23-2020

Hi Dears,

I have a problem with AP Air-CAP2602e-e-K9

I can't access it via console, and these symbols are appearing.

Kindly note that the AP is in standalone mode.

Scott Fella · ‎09-23-2020

If your baud rate is set to 9600 8N1, then it looks like that so was flashed somehow and no way to recover that.

-Scott
*** Please rate helpful posts ***

mzedanmzedan · ‎09-24-2020

Dear Scoot,

Thanks for your reply.

Exactly, I had set the settings to 9600, 8N1

Do you mean that AP is not available to use again?

Sandeep Choudhary · ‎09-24-2020

Hi,

make sure your flow control is set to none. Swithces and routers allow it to be RTS/CTS, but the AP needs flow control to be off.

and please also try with some other console cables(USB-->rs232).

Regards

Dontf orget to rate helpful posts