cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
462
Views
0
Helpful
3
Replies
Niels Marien
Beginner

AP MAC adresses in flexconnect group configuration not showing the cli config file

Dear,

Could someone please check and verify of this is normal.

When I export the config from the GUI or CLI, I don't see the which AP are listed under which Flexconnect group.

I need to have this information to automatically update the config on the N + 1 redundancy controller.

Now I have to visually check every Flexconnect group and then copy past the mac of the AP to the other controller…. ☹

Kr

Niels

1 ACCEPTED SOLUTION

Accepted Solutions
omz
VIP Collaborator VIP Collaborator
VIP Collaborator

Hi

WC01) >show run-config commands

...
flexconnect group 00027A add flexconnect group 00027A ap add 34:db:fd:xx:xx:xx flexconnect group 00027A ap add 34:db:fd:xx:xx:xx flexconnect group 00027A radius ap server-key <hidden> ...

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.0.152.0

 

Can see the AP MAC in flexconnect config.

View solution in original post

3 REPLIES 3
superego
Beginner

What command did you use to show the running config in CLI?

 

Try:

***for the full running config***

show run-config commands 

 

***for flexconnect config***

grep include "flexconnect group" 'show run-config commands'

 

***Please mark this as an acceptable solution if it helped.  Thanks.***

There is a part of the flexconnect config, but no AP's mac.
Is there in your setup? Because that was the question in the tread.
omz
VIP Collaborator VIP Collaborator
VIP Collaborator

Hi

WC01) >show run-config commands

...
flexconnect group 00027A add flexconnect group 00027A ap add 34:db:fd:xx:xx:xx flexconnect group 00027A ap add 34:db:fd:xx:xx:xx flexconnect group 00027A radius ap server-key <hidden> ...

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.0.152.0

 

Can see the AP MAC in flexconnect config.

View solution in original post

Create
Recognize Your Peers
Content for Community-Ad