AP memory list of wlc

[Charlie Grey]

Hi,

after an AP join a controller, it will learn the list of all the wlc in the mobility domain in which it can connected in event when the current connected wlc is down.

can i know how to erase this this memory of wlc??

does doing a reboot wipe it clean or must do restore AP to factory default? or wat??

[Leo Laohoo]

Enter the below command into the AP:

clear capwap ap controller ip address

[Charlie Grey]

on an AP, r we able to issue command to the AP to check the list of controller in memory?

[Leo Laohoo]

Not that I am aware of.

[Scott Fella]

Or else just erase nvram. 

1. Disconnect power from the access point (either the power jack for external power or the Ethernet cable for in-line power).
2. Press and hold the MODE button while reconnecting power to the access point.
3. Once the access point is powered on, you can use the command erase nvram: to erase the NVRAM.
   • Additionally, you might need to erase the private-config to remove the IP address of the access point and the controller using the following command: erase private-config.