Anyone know why I am getting the following message on my repeater AP?
%DOT11-4-CANT_ASSOC: Interface Dot11Radio0, cannot associate: No Response
My repeater aP dot110 interface shows a status of reset when I set the station-role repeater. I was able to get the repeater AP to associate to the Root AP a few times but then it would lose connectivity. Is this issue related to RF? My test AP's are very close to each other.
Here is what I have.
Repeater AP
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
ssid xxxxx
authentication open
authentication key-management wpa
infrastructure-ssid
wpa-psk ascii 7 xxxxxxx
!
short-slot-time
parent 1 0000.aaaa.bbbb
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role repeater
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
Root AP:
interface Dot11Radio0
mac-address 0000.aaaa.bbbb
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
ssid xxxxx
authentication open
authentication key-management wpa
infrastructure-ssid
wpa-psk ascii 7 xxxxx
!
short-slot-time
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
channel 2412
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
Thanks
