Wireless

Hi,I need to install some anntenas in a warehouse. The problem is that the warehouse is too high ( 20 metres ). Which is the best anntena to install?thanks

We would like to use 802.11a as the backhaul of our wireless systems at certain locations. whe we were configuring the test units, the configuration is almost identical to that of the 802.11G radio. Meaning, that it gives basically to genrall rools, ...

Using an 1100 running c1100-k9w7-mx.122-13.JA4.Without WEP(128 bit) it works fine. I am using it for 7920 wireless phones and laptop access. As soon as WEP is enabled both the phone and laptop associate to the AP, but cannot route, cannot ping the AP...

I must be missing something. When I select "use this AP as WDS", the Wireless Domain Services Priority field will not take input, and of course, I can not then apply WDS. Using system software version 12.3(2)JA2.I believe I have followed the insructi...

We recently purchased a Cisco Airnet 1100 series Wireless Access Point. Everything is working fine on the Access Point so far (everyone can connect ok). The only problem we are having is getting the Event Log to display the correct time. Right now th...

I am trying to get our wireless network up. I am using PEAP with MS-CHAPv2, ACS 3.3, 1100 series access points, WDS, Dell internal centrino cards, and Active Directory for user login. We currently are not using Group Policys but running logon scripts...

Hi,I have a customer who has a notebook that does not support LEAP. It supports a protocol called Protected EAP (PEAP).It's Authentication Method uses "Secured Password - EAP-MSCHAPv2" and I don't know whether it is supported in Cisco Aironet.The thi...

hiI am having a problem in accessing the Cisco ap 1200 B series with HTTP WRITTEN IN C CODEWhen i am doing that i am getting the response from the ap as401 Unauthorizedwith WWW.Authenticate:Basic realm=" level 15 cccess"< HEAD> <TITLE> Authorization ...

how to write a config file so that it can be configured through HTTP program.plz helpmalli

What is the difference between buying a "pre-configured bundle" AIR-AP1231G-A-K9 (that includes AIR-AP1210 platform and AIR-MP21G-A-K9 Radio Module) and purchasing the components separately? Would it make any difference in terms of adding an AIR-RM20...

Hi,We are using Cisco 1200 series IOS based access points. On the client side we have a mix of Cisco,Intel,etc wireless cards. PEAP is being used for authentication and TKIP as encryption.In this scenario1. Can we use WDS for rogue AP detection ?2. C...

Hi all,could someone tell me if it is possible to have 2 1300 device configured as follow:- 1 aironet 1300 configured as Root Bridge With client association ( Root bridge & AP ) - 1 aironet 1300 configured as Non root Bridge with client association.I...

Been reading a lot about wireless security and there's a lot to absorb. But in an ideal Cisco enterprise environment (all Cisco clients a/b/g), using LDAP and W2K SP3 Laptops, which security method would be best suited for our environment. Been looki...

For some reason our WLSE boxes got turned into ACS servers...so now we get to recover and set them up from scratch. I was not here for the intitial setup so this is my first time messing with them.First I am using the 2.0 disk but I plan to upgrade t...

Everybody know, WLSE display the rogue Cisco AP as "Unknown Vendor", which is not connect to the same network. Thanks