AP1200 Boot Failure

[jimh]

I have a Aironet 1200 that the 3 LEDs blink amber once every second.  I have tried powering up holding the mode button for 30 sec but does not change the behavior of the AP.  It worked for awhile after upgrading the firmware which is leading me to believe that the upgrade was successful.  Is there any way to recover from this failure?

[Leo Laohoo]

HI James,

Unless you console into the AP there's no way of knowing if the AP lost it's config or what.   Turning amber could mean either it's booting, can't find a WLC or some hardware failure.