cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
663
Views
0
Helpful
2
Replies

AP1200 User Manager blocked

Nick Howells
Level 1
Level 1

I have a few AP1200's which have the WEP keys and User Manager names set, therefore i cannot connect wirelessly. I have tried connecting over console and see the unit boot up, however when i try to enter Setup> Security page it prompts me for a Username, this i do not have.

Is there any way i can 'crack' these? any process whereby i can reboot the units and restore to defaults?

Nick Howells Head of Solutions Sales - Collaboration STS (Structured Technology Services) T: 0116 240 8820 | D: 0116 240 8832 | M: 07764 710396 E: nickh@sts-communications.com | W: www.sts-communications.com
2 Replies 2

tepatel
Cisco Employee
Cisco Employee

Here is the url which dicsuss about password recovery for Access Points

http://www.cisco.com/warp/public/102/wlan/pwrec-2.html#resetap

Above procedure will bring the AP to factory default settings.,

Thanks a lot for your help, i'll give that a try.

Nick Howells Head of Solutions Sales - Collaboration STS (Structured Technology Services) T: 0116 240 8820 | D: 0116 240 8832 | M: 07764 710396 E: nickh@sts-communications.com | W: www.sts-communications.com
Review Cisco Networking for a $25 gift card