We've got some new AP1240 running LWAPP. In experimenting with how they get their connection and Config to the 4400 Controller we found doco stating there are some LWAPP commands available.
"
Configuring Controller Information
To manually configure controller information on a new (out-of -the-box) access point using the access point CLI interface, you can use these EXEC mode CLI commands:
AP# lwapp ap ip address <IP address> <subnet mask>
AP# lwapp ip default-gateway IP-address
AP# lwapp controller ip address IP-address
AP# lwapp ap hostname name
"
We don't seem to find these commands available in CLI. Don't show up under help and command not found when typed in manually. Any ideas ??
Yes we know about the DHCP and DNS options we are just testing out everything.
