cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1404
Views
0
Helpful
4
Replies

AP1262N AN Radio configuration (autonomous)

michael.frey
Level 1
Level 1

Recently installed a 1262N AP in autonomous mode. Have both 2.4 and 5Ghz radios running- Both on separate SSID and VLAN.  I think I have 5Ghz channels using 40Mhz bands (bonded) but when I do iperf throughput test I only get about 25Mb throughput. I am sitting within 10 feet of the AP. When I switch to 2.4 I get around 60Mb and that's not bonded. I have tried multiple interfaces on my client side laptop I'm testing with since I thought maybe it was a quirky card or driver but I get same results. Am I doing something wrong here?  My laptop shows a 300Mb connection to 5Ghz and 144Mb on 2.4Ghz but I know that's not true thorughput so that's why I was testing this to see what I was really getting and now I'm confused.

Thanks!

4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame
I think I have 5Ghz channels using 40Mhz bands (bonded) but when I do iperf throughput test I only get about 25Mb throughput. I am sitting within 10 feet of the AP.

Stupid question from me:  Do you have all SIX antennas attached?  If you do, please specify what models you are are using.

michael.frey