APCisco 1242 LAP in H-REAP mode.

[lorenzopaca]

Hello,

I 've two questions for the h-REAP mode on a WLC2100 (7.0.98.0) with 1242 Cisco :

first: what the maximun number of clients can connect on a H-REAP LAP ?

second: I've configured one WLC with 4 LAP Cisco 1242 in H-Reap mode: the power level of 4 LAP are configured in auto global configuration TPC.

But I don't understand why the power level is still on 1 after installing ?

Thank you for your Help.

Regard.

Lorenzo

[Scott Fella · Accepted solution]

Maximum amount of clients has always been in the past 15-25.  However, it depends on your users.... you can have 3 users that do file transfers and that would be you limit.  SO your max number of client can vary depending on your users bandwidth requirements.

As for h-reap, look at this section:

http://www.cisco.com/en/US/products/ps6087/products_tech_note09186a0080736123.shtml#t7

[lorenzopaca]

Hi Scott,

thank you for your reply.

I 've tested the good fonctionality with 30 clients on one AP in H-reap mode.I had 2 problems:

the first: default limit client by AP: 12   upgrade to 35.

the second: Load balancing mode enable : windows: 5 upgrade to 20.

bye.

Lorenzo

[Scott Fella]

Lorenzo,

What do you mean by problems?  Are you talking about the Client threshold for traps set at 12?  What do you mean regarding the load balancing windows 5 upgraded to 20?

[lorenzopaca]

Yes, increasing these values, I have a best job with clients. 20 at 30 Clients on 2 APs.

Lorenzo