cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
843
Views
0
Helpful
6
Replies

apple tv mirroring

josephschung
Level 1
Level 1

Sir,

I setup a autonomus AP to let both apple TV and ipad access the wireless network so that ipad can mirror through apple TV.

It works when I use an old aironet 1220 with WEP encryption.

But it does NOT work when I replace the 1220 with a new 2602i, which run 802.11n and aes-ccm encryption. The ipad just does not show the button when you double press home button.

Any idea why?

Thanks.

1 Accepted Solution

Accepted Solutions

Stephen Rodriguez
Cisco Employee
Cisco Employee

you may need to go in and disable igmp snooping

conf t

no ip igmp snooping < IIRC

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post

6 Replies 6

Scott Fella
Hall of Fame
Hall of Fame

I think its an issue with the v15... With other AP models, others have had better luck with running the v12.4 than the v15 which is the only autonomous code for the 2602.  Older models like your 1220 can run the v12.x which seems to just work. You might just be better off opening a TAC case and see what they come back with.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Stephen Rodriguez
Cisco Employee
Cisco Employee

you may need to go in and disable igmp snooping

conf t

no ip igmp snooping < IIRC

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

Steve is that specific to v15 ?

__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
__________________________________________________________________________________________
‎"I'm in a serious relationship with my Wi-Fi. You could say we have a connection."

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

I've seen this kind of oddity with both CUWN and aIOS.  Sometimes you need to toggle that to make it work

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

I agree. Ive configured it both enable and disable on CUWN and it worked. But Ive seen in some cases it didnt.

__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
__________________________________________________________________________________________
‎"I'm in a serious relationship with my Wi-Fi. You could say we have a connection."

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

FYI, it is fixed by below commnad.

no dot11 igmp snooping-helper

Thank you all for the contribution.

Review Cisco Networking for a $25 gift card