07-07-2015 10:41 AM - edited 07-05-2021 03:31 AM
i see this being discussed allot with varying opinions regarding speeds beyond 54MB. I believe i have the encryption set correctly, and i have the AES enabled, but i am still seeing 54MB?
i attached a cleansed config from my "sandbox" hoping that someone may point out where i may have overlooked something.
thanks in advance.
07-07-2015 10:55 AM
it doesn't look like you have the MCS rates enabled.
This is from my AP:
beamform rssi 65
beamform ofdm
speed basic-36.0 48.0 54.0 m4. m5. m6. m7. m10. m11. m12. m13. m14. m15.
channel width 40-above
channel 5180
station-role root bridge wireless-clients
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
HTH,
Steve
07-07-2015 11:15 AM
good point... im looking at trying to make some changes there in the GUI, but none of them stick... very weird
07-07-2015 05:25 PM
In CLI, "speed default" may also work under radio interfaces.
Provide "sh dot11 asso <clinet_mac> " output to see when you done that modification.
HTH
Rasika
07-07-2015 12:27 PM
i got it, i just went into the CLI and did it from there instead.
thanks, that worked!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide