02-05-2015 01:43 AM - edited 07-05-2021 02:26 AM
Hi ,
I was using Local AP with 60 ap connected WLC 4404. But I set hreap ap one of them because speedtest of 1140 ap is very low . (4 Mbbps)
than I had done hreap mode . speedtest increase to 60 Mbps . but when 7921 ip phone room between hreap and local ap , pacet loss is done .
How can I sokve this problem
Thanks
02-05-2015 02:04 AM
You shouldn't mix. If that location is remote and h-reap fixes your issue with speed, then change the APs to h-reap and also create an h-reap group and place APs in that group. There is a limit to 25 APs in an h-reap group also. So if you have to create more than one, you might have roaming issues between h-reap groups. So place APs in groups that are near each other. If the APs are local to the WLC then local mode should be used and maybe figure out why local mode is slower as it shouldn't be like that.
-Scott
02-09-2015 02:34 PM
Which type if encryption are you using ?
WPA2 PSK
WP2 Enterprise // EAP ?
Greetings
Philip
02-13-2015 06:53 AM
WP2 Enterprise
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide