Bootp and Access Point 1231G

[I.Schneider]

Dear all,

Is it possible to load a config-file from a bootp-server to an access-point?

Which commands will I need on the cli?

THX for the answers

Kind regards,

Ingo

[mchin345]

Click Read Config File From Server. The management system checks the server for several possible configuration filenames while attempting to load the configuration file. If the management system doesn't find the first filename, it continues to the next until it finds the file and loads it. It checks the server for the following names in the following order:

a. [system name].ini

b. [IP address].ini

c. [boot file from DHCP/BOOTP server].ini

d. [boot file from DHCP/BOOTP server].ini by TFTP