Bugs in CAC Tool 2.0?

[seanm]

I have converted 5 350 series APs from VxWorks 12.01T1 to IOS 12.2(13)JA1 and have run in to the following issues:

* The enable password is in the generated conversion template (if I look at the file directly) as <END>enable password 0 <ena_passwd>, but does not make it in to the actual device IOS config. Yes, I set the enable password in the security configuration portion of the CAC.

* After the conversions using CAC, I telnet to the AP and compare the startup and running configs. They are identical. I issue a reload command and when it comes back up, the configuration is gone and I have a default config. I was not prompted to save the config.

Unfortunately I do not have smartnet on any of these so cannot open a TAC case. Has anyone else seen this problem?

[#2]

This is a known issue, check the bug tool kit for details

[seanm]

Can you give me a bit more of a pointer. I went through the bugs for AP350, but found nothing relevant. There is no entry for the CAC tool specifically (that I saw), and nothing on IOS->VXWORKS.

Thanks.