Calibration error message in WCS(MSE)

[ajmadriaga]

I get a calibration error message in WCS when I try to add data points in the RF calibrate models section.  Here is the error message:

Error in Calibration. MessageMEDIATION-5, WcCalibration!x.x.x.x!xx:xx:xx:xx:xx:xx,row Status,No access

The first set of x is the IP address of the controller and the other x is the MAC address of the wireless system that is being used for calibration.

[Frederik Schon]

Hi,

Which Wireless-Card you used?

Best you use the Cisco CB21AG PCMCIA Card. I had similar problems with intel wireless chipsets

Sincerely,

Frederik