Can not access autonomous AP by GUI

[wfqk]

Hello,

Autonomous AP c1140 and PC can ping each other. Ip address 10.0.0.10/24 is added to BVI interface. http and http secure-server are enabled. But it cannot be accessed by GUI. Do not know why cannot access

Any suggestions would be highly appreciated. 

[Flavio Miranda · Accepted solution]

Hello @wfqk

 Silly question but just to make sure.

Are you using https://10.0.0.10

Can you do SSH or telnet ? 

Have you tried with different browser?

Do you have the following command right?

ip http secure-server

ip http server

[wfqk]

Thank you

[m.rana.ku]

Hi,

In the following video step by step process has been shown How to Configure Cisco AIRONET 3602i Autonomous/Standalone Access Point using GUI with WPAv2 Authentication Key.

https://www.youtube.com/channel/UCmZZ2BNGXQH1HPS3uIVnr7A?sub_confirmation=1

https://youtu.be/AwuWsGGofT4

Configuring Aironet Access Point with WPAv2 Authentication in GUI :
1. In Easy Setup
Under Network Configuration
Edit AP hostname, Static IP, Subnet mask and Default Gateway
Under In Radio Configuration
Create SSID name WLAN_New under Radio 2.4GHz and select Broadcast SSID in Beacon
2. Apply Encryption Modes to AES CCMP
3. Enable WPAv2 and apply WPA Pre-shared Key: to SSID
4. Enable Wireless Radio Interface (Radio0-802.11N2.4GHz/ Radio1-802.11N5GHz) UP
5. Save the configuration