Cannot change AP configuration after disabling warning

[roger perkin]

I have been configuring some access points on a 2504 controller. 

Every time you make a change you get the warning saying this may disrupt clients etc. 

Tick the box if you don't want this 

I had ticked the box and now for some reason cannot make any changes to APs

I have to make the all via CLI

Does anyone know what might have happened of how to re-enable the warning so I can see what is going on 

Regards, 

Roger

[Milos Megis]

I think that it is not configuration of WLC.

It should be setting in web browser. What happened if you use other web browser ?

Try remove all user settings in web browser or just reinstall it.

[Sandeep Choudhary]

HI,

you are correct, It also happened with me with my old 2112 WLC.

WORKAROUND: You can logout and login again to WLC. Then you can make changes.

Regards

Dont forget to rate helpful posts