Wireless

Hello everyone, We found one AP in our company registered to a third WLC, but there is only primary and second WLC was configured on the WLC to which the AP is joined to . We suspect DHCP option 43 made this phenomenon, but the DHCP server is managed...

Hi Team, I'm trying to setup a 5508 WLC from scratch. I have configured the device with basic configuration via CLI.  The interface configuration is as follows, WLC 1. Management interface: 10.100.10.21 / Gateway 10.100.10.254 (/24) 2. service port :...

Hello everyone, 1.Could you advise if the AP country code must match the configured WLC country code? Assuming my AP country country code is China, the WLC configured country code is Pakistan, they are in same regulatory domain, could my AP join the ...

can i setup ap sso without using RP ports connectivity on 5508 controllers which are located in two different buildings , when the two buildings are connected by a layer 2 port-channel using single mode fiber  controller 1 - core switch -------------...

Hi All, Good day! We have configured 1 SSID and used 1 Radius server for authentication. I would like to ask if we can create a backup authentication on Meraki Cloud control that if we our Radius server fails we can still use Local Autotication like ...

what is the difference between C1FPAIRK9 and C1FPAIR500K9 ?

Hi guys, here my configuration:  - WLC : Cisco 5520  - Software Version : 8.2.141.0  - Access Point : AIR-CAP3702 Tested Clients : 1) Samsung Android (Galaxy A3 2016 - Android 6.0.1) - DHCP ON 2) IPAD (IOS 9) - DHCP ON 3) One Plus One - DHCP ON Only ...

This is happening on two different AP's in the enterprise network.  One of them can be disconnected and reconnected to the switch and the AP will recover.  The recovered AP will then work for several days or over a week without a problem, then random...

Hi thereour customer has the following setup: 1 x WLC 5760 with IOS XE 03.03.03 -> planned to upgrade to 03.06.00 in a few daysn x Cisco Aironet 3702i access points There are no problems at all with most of the client devices, but some clients with W...

Is there a way, using either Prime 3.0, or the 3850 controller ios-xe 03.06.05E interface, or a combination of both, to view real time radio utilization? We will be testing an application buildingwide, and I need to be able to see at a glance, in rea...

Hello, All the tech docs state that the client authentication process take place before the association. However on the controller I see clients which are associated but not authenticated. How is this possible?

I am trying to view my Dlink IP Camera through my mobile phone using Dlink Viewer OWLR app. I can view this via WIFI, but if I cant view this externally using my 4G or 3G data via mobile phone. To configure my camera for external access so that I can...