Cannot enter password for AP1262 access point in console port

PatDaw3175298 · ‎08-01-2019

I am trying to set up a few air-ap1262n-nk9 access points but am struggling to log in via console Port.

When connected to my router, it gets an assigned ip address of 192.168.1.106 but won't connect to the gui if I enter that ip into the browser.

Am I doing something wrong?

Update, worked out it has been flashed with a lightweight image. Now have to try and get the autonomous image.

marce1000 · ‎08-01-2019

- If applicable try a factory defaults reset first -> anyway.

M.

-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

PatDaw3175298 · ‎08-01-2019

@marce1000 wrote:

- If applicable try a factory defaults reset first -> anyway.
M.

Thanks for the reply. I have already reset the AP a few times with same results on 2 out of 3 access points. Have not attempted to configure tbe 3rd one yet.

patoberli · ‎08-06-2019

See here: https://learningnetwork.cisco.com/thread/14405
Check the part about "Using a TFTP Server to Return to a Previous Release"