08-13-2013 11:30 PM - edited 07-04-2021 12:38 AM
I have a WLC model 4402 running 7.0.235.3. I am trying to make a CAP2602 to join the WLC but it is unable to. Doesn't the 4402 with this software support the 2602? The WLC has a license for 12 AP's, only 9 in use. Currently there are only AIR-LAP1131 connected to the WLC.
The debug on the WLC shows this;
*spamReceiveTask: Aug 14 08:16:07.133: 00:3a:9a:ab:c0:74 Received LWAPP DISCOVERY REQUEST to ff:ff:ff:ff:ff:ff on port '29'
*spamReceiveTask: Aug 14 08:16:07.133: Ethernet Source MAC (LRAD): 00:3A:9A:AB:C0:74
**spamReceiveTask: Aug 14 08:16:07.134: 00:3a:9a:ab:c0:74 Discarding discovery request in LWAPP from AP supporting CAPWAP
The CAP2602 gets its IP from the switch, and keeps on changing IP's all the time. I am able to ping it until it changes IP.
08-13-2013 11:35 PM
I can answer this myself, after some checking I found out that the last software-version for WLC4402, which is 7.0.240, does NOT support the 2602 access-points according to this document,
http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn7_0_240_0.html#wp784295
08-13-2013 11:45 PM
2600 AP requires firmware 7.4.X.
7.4.X code is supported on the 2504/5508/WiSM-2 and later. It's not supported in 4400/WiSM-1.
08-14-2013 11:59 AM
Hello,
As per your query i can suggest you the following solution-
The controller software is factory installed on your controller and automatically downloaded to the access points after a release upgrade and whenever an access point joins a controller. We recommend that you install the latest software version available for maximum operational benefit.
Change the IP address of the management interface.
Hope this will help you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide