Wireless

Hi Everybody I look after over 40 5508s WLC and we have upgraded a few of them to 8.0.110.  We have had 2 in the last week die.  when I say die I mean we loose everything the units no longer even respond on the console port.  Both of the controllers ...

We have a AIR-WLC2112-K9 with several access points.Some clients are not able to connect and we can see that they are trying to connect to 802.11b and are in status Probing.802.11g clients are connecting normally.Does anyone have an idea what can be ...

Looking for help with Asset Tags reporting inaccurate locations. Most tags are reporting 100' more or less from their actual location. We are Using Cisco Prime 2.1.

Hello,I need to develop a solution of wIPS, but I'm not sure about the compatibility between the MSE and the WLC. My WLC is in 7.6.100 version and the MSE is 3310 model. Reviewing documentation, the MSE can only update until 7.3 version. Somebody kno...

Hi all,we have a Cisco Prime 2.2.0 and a redundant (SSO) WISM2 pair (8.0.110.0) and about 700 APs.After conversion to redundancy of WISMs and because of different local configurations of some APs we have to change the IPof the primary and secondary c...

Hi Guys;I am after some help in trying to identify what WiFi inverted and WiFi Invalid channel alarms are, I have read the post which gives a good explanation:https://supportforums.cisco.com/discussion/11308356/wifi-invalid-channel-wifi-inverted-spec...

 We need a solution for the wireless network inside the campus area for our new project. Our requirement is we have a datacenter inside the campus. So the users standing anywhere in the campus area should be able to access the application which is ru...

Hello,Upgraded WLC 2504 from 7.6.120 to 7.6.130 and now I cannot log into the lobby ambassador portal.  I use the same user id and password, then it  says page cannot be displayed.  I created another lobby ambassador account and I am getting the same...

I have a WLC and having some SSIDs for Flex-connect mode (Mobility-group). Users trying to connect the wireless network using BYOD device but while they are trying to connect , it spins and spins . I checked controller , client is connected and got I...

Hi allWe have a scenario where we have a Cisco 3850 (WS-C3850-48P-S) switch stack configured with a WLC. This is used for the corporate wireless connectivity. This is on the inside of a firewall pair.On the other side of the firewall we have a 3850 s...

Since I moved  our WLC Controller ( 5508 ) from  Version 7.0 to Version 7.2.111.3   I got above failure messages.Until now I changed the radius timeout from 2 to 10 seconds and also I disabled the aggressive failover without success. Any idea what el...