cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1151
Views
0
Helpful
4
Replies

CAP-AIR to SAP

I want to convert CAP-AIR 2600 access point to SAP but i can't connect to it via console ..it needs controller but i haven't.

4 Replies 4

Sandeep Choudhary
VIP Alumni
VIP Alumni

HI,

Yes you can convert it to SAP easily.

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html#wp160918

 

https://supportforums.cisco.com/document/71501/installing-autonomous-ios-aios-lightweight-ap-cli

https://supportforums.cisco.com/document/57476/lwapp-autonomous-conversion-and-vice-versa-access-points

http://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

 

https://www.youtube.com/watch?v=QQ_NuxdRhQ4

 

Regards

Dont forget to rate helpful posts

I can't access it via console connection it needs WLC and I don't have it. !!

AP need to WLC to get configuration file  but if you want to convert it then try to reset it

 

Reset AP:

 

Remove power supply.

Press mode and connnect power supply agin while pressing mode buttion(10-15 seconds till status light shows amber colour)

then try to convert it.

Regards

I can't access it via console connection it needs WLC and I don't have it. !!

Review Cisco Networking for a $25 gift card