08-06-2020 09:50 AM - edited 07-05-2021 12:22 PM
I would like to setup AP High Availability to set the Primary and Secondary WLC.. it is simple if I do this one AP at a time but when you have over 200 AP's it is tedious..
Is there a way to change all AP's at once.. It would save a ton of time and any human errors.
thanks
Solved! Go to Solution.
08-06-2020 10:48 AM
08-06-2020 12:15 PM
08-06-2020 10:48 AM
08-06-2020 11:15 AM
that sounds like the way to do it..
What would the CLI syntax look like?
08-06-2020 11:50 AM
08-06-2020 12:15 PM
08-12-2020 11:52 AM
Also keep in mind that you cannot have the same controller as both primary and secondary, so if you are trying to swap a <-> b you will get an error. You'll need to use a third controller (real or imagined) temporarily as a place holder a -> c, b -> a, a -> b
08-06-2020 10:58 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide