03-07-2008 04:11 AM - edited 07-03-2021 03:30 PM
How can I change the password for controller based Access Points on the WCS?
On the controller itself I know how it is done.( config ap username <USERNAME>password <PASSWORD> <all | AP Name>
But how is it done on the WCS wher 3 controller exists?
Thanks for an answer
03-10-2008 09:18 PM
this will be available in WCS release 5.1.x.x (under "configure - controller templates - system")
04-01-2008 08:20 AM
global username and password can be changed via:wcs.this feature was supported on wcs:5.0.56.0.
1)click configure>(click link under name of any controller>system>AP username and password.
2)give AP username and password .
3)give enable username and password.
4)click save.
now try to login to any of your AP using this username and password.ANY future AP joining controller will use this username and password.
if you want particular AP username and password to be changed.then
1) click AP.CLICK link under ap name.
2)enable check box over ride global username and password.
3) give username and password
4)give AP enable username and password.
5)click save.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide