Wireless

Hi,I would like to know if would be possible to use Cisco Aironet 350 series APs as repeaters with a WLC 2106 and 1131AG Ap's?Actually I've configured 5 AP's 1131 to use them with a WLC 2106. But, I'd need more coverage and for that porpouse I'm tryi...

I have 1310 Ap/Bridge with integraded antinna. if we use it as outdoor point to pint bridge configuration. then what will be max distance at 54.

Help! If I use ACS 3.3 have no problem to connect the Aruba controller via Radius to the ACS. When using ACS 4.1 it is not (?) possible, suspect that this has something to do with the "Key Wrap" line in AAA Client on the 4.1. How to "translate" or ov...

can autnomous APs be managed by a wlc or wcs? Or just wlsm/wlse?

Hi.I have a problem.My network - build on WLC 4402 with LAP 1242.Some clients have problem with connect to network - 2 or 3 time in day - for 5-10 minutes. I think that cause by client see 3 LAP with good signal-strength and try to roam from one AP t...

HI, I have an AIR-LAP1242AG AP, I don't understand why they have two RF ports (Left / Primary )for A and B, do you know why ?.

I'm getting this error when I try to downgrade a 1231 from LWAPP to Autonomous mode. The transfer takes place and then it starts extracting file and ends with this message.Any ideas?

Anyone run into any problems running 12.4(10b) on 1310G radios running as P-t-P bridges? I tried 12.4(10b)JA3 and got a really strange asymmetrical association rate; 1Mbps on one side and 54Mbps reported on the other. It ran extremely slow so I dow...

hion my wlc 4404 when i got to wlan>mywlan, i can choose which radios can connect to the wlanlike a, a and g, or b only. i was told by a co-worker that if someone with a b radio connects to the wlan, then the access point will only transmit b from th...

Gurus,My goal is to configure my (2) 1131's the same, with (2) SSID's, one being visible and the other hidden. I would prefer to use the GUI if possible, but can do command line.The visible SSID (named Public) is to have access to Vlan 15 only.Proble...

We have a mix of the AP's with and without Power Injector because only some switches have the POE.On WLC what setting has to be checked on the Advanced Tab for the AP?1. Some times AP gets installed with POI and after couple of weeks the radios go do...

Good evening everyone. I have a requirement for wireless access in our state offices. There are all over Wide Area Links frac T-1 to T-3's. The requirement is for AES using EAP-FAST. The wireless users must be able to work if the WAN link goes down. ...

Hi all, I have wireless network with Wireless Lan Controller 2100 and Light Weight Access Point 1300.All thing run well.But when we need some change on network, i changed IP of LAP 1300 to incorrect IP address. So it can not communicate with Wireless...