cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
405
Views
0
Helpful
1
Replies
Fernando Lacarra
Beginner

Check antennas status AP 1252 in lower power mode

Hi all, I want to know how can I check the status of antennas of AP 1252 in lower power mode.

My customer has not yet the POE Plus switches so the AP can not make the most of use of all antennas. AP 1252 has 3 Rx and 2Tx antennas but it does not use all of them because it has not POE plus.

How can I see the antenna that are up? With the following command I can not get it: "show controller dot11 0". It only shows that AP is running in lower power mode.

Thanks by advance

Fernando

1 REPLY 1
Leo Laohoo
VIP Community Legend

Hi Fernando,

Upgrade the IOS to 12.4(10b)JDA3 (or later) and the 1250 should be able to operate both radio modules at 15.4w.

Content for Community-Ad